Model:Bond-Rowland SSBM

Bond/Rowland Single Stage Ball Mill Model

This is a multi-stage crushing plant feeding a ball mill model that estimates the specific energy consumption (E_BM) using the Rowland interpretation of the classical Bond work index equation including Rowland efficiency factors.

$E_{ssbm} = Wi_{C} \times \left ( \tfrac {10}{\sqrt{ 9400 }} - \tfrac {10}{\sqrt{ F_{80} }} \right ) + Wi_{RM} \times \left ( \tfrac {10}{\sqrt{ 2100 }} - \tfrac {10}{\sqrt{ 9400 }} \right )\times EF_4^{RM} + Wi_{BM} \times \left ( \tfrac {10}{\sqrt{ P_{80} }} - \tfrac {10}{\sqrt{ 2100 }} \right ) \times EF_4^{BM} \times EF_5$ ^{Rowland, 2006}

$E_{total} = E_{ssbm} \times CF = E_{crusher} + E_{ball}$

where CF is an optional calibration factor, use 1.0 for normal situations.

The rod mill oversize feed factor (EF₄^RM) is calculated using the greater of the sample's rod mill or crushing work index (which is usually the Wi_RM). The optimal feed size and EF₄ are both calculated using whichever is greater.

$EF_4^{RM} =\left [ 1 + \left( \frac{ (0.907 \times Wi_{RM} - 7) }{ \left (\frac{F_{80} }{ P_{80}} \right )} \right) \left ( {\frac{F_{80} }{ { 16 000 \left(\frac{14.33}{Wi_{RM} } \right )^{0.5}}} }-1 \right ) \right ]$

where:

• F₈₀ = 9400 µm
• P₈₀ = 2100 µm

The ball mill oversize feed factor (EF₄^BM) is always calculated with the ball mill work index. The optimal feed size for the EF₄^BM is always calculated using the rod mill work index.

$EF_4^{BM} =\left [ 1 + \left( \frac{(0.907 \times Wi_{BM} - 7) }{ \left (\frac{F_{80} }{ P_{80}} \right )} \right) \left ( {\frac{F_{80} }{ { 4000 \left(\frac{14.33}{Wi_{RM} } \right )^{0.5}}} }-1 \right ) \right ]$

where:

• F₈₀ = 2100 µm
• P₈₀ = the specified circuit product size, µm

Secondary and tertiary crushers

The model does NOT validate the choice of crushers for the specified sizes; it simply calculates a specific energy based on the power drawn and the throughput dictated by the ball mill circuit. The throughput in the crushing circuit is NOT calculated and the motor sizes are NOT checked to see if they are suitable for the duty presented.

The choice of crushers and arrangement is normally based on volumetric flow and not on power draw. Use a crusher catalogue or another tool, like Metso's Bruno software, to determine the size and arrangement of the crushers ahead of the ball mill(s).

Default parameter values

• Assumed crusher product (T₈₀) size, µm = 9400
• Hypothetical rod mill product size, µm = 2100 (mid-point of the range between typical rod mill work index test P₈₀ and typical ball mill work index test F₈₀).