Bibliography: Mill power draw models

Mill Power Draw Model Bibliography

Mill power draw models are used to predict the usable power draw that a particular mill will generate.

Austin SAG Model

The Austin SAG model was published in:

1. Austin, L.G., A mill power equation for SAG mills, Minerals & Metallurgical Processing; Society for Mining, Metallurgy & Exploration, February 1990. [1]

Morrell Models

The Morrell models for SAG and ball milling are all derived from the same reference and differ in some default parameter values and in the geometry of the mill charge (grate versus overflow discharge).

1. Napier-Munn, T.J.; Morrell, S.; Morrison, R.D.; Kojovic, T., Mineral Comminution Circuits; Their Operation and Optimisation; Julius Kruttschnitt Mineral Research Centre, Indooroopilly, Queensland, Australia. First ed. 1996, republished 1999 & 2005. [2]

Loveday/Barratt Model

Loveday produced a largely empirical model using a "Power Number" parameter. Barratt developed a chart of "Power Numbers" for SAG mills that was published in:

1. Barratt, D.J. & Sherman, M, Selection and Sizing of Autogenous and Semi-Autogenous Mills, Mineral Processing Plant Design, Practice, and Control. Society for Mining , Metallurgy & Exploration (SME), 2002, Pages 755-782.

Nordberg Model for Ball Mills

1. Rexnord Corporation, Nordberg (Red Book), third edition, section 17

Nordberg Model for SAG; J. Starkey et al

1. Starkey, J.; Hindstrom, S. & Orser, T. Choosing a SAG Mill To Achieve Design Performance; AGM of Canadian Mineral Processors, 2003. Pages 305-316
2. Starkey, J. Impact on Grinding Mill Design of Recent New Discoveries; Society for Mining , Metallurgy & Exploration (SME), 2009, Pages 340-346