How to use the Litho table
The Sample Definition & Litho database table
Sample names must be declared before test data may be attached to those samples. The 'Sample name' is declared in the database "Litho" table which contains these sample name definitions and additional information about the sample, such as its geology or its locations within a section of drill core.
The optional geologic information is used to partition other test results into groups. Those groups are commonly lithology, alteration, and zone. The Litho table also cab contain optional drill hole information, for those samples derived from drill holes, that allow geologists to relate the spatial positions of grindability samples within geological models.
The mandatory field is:
- Name: the sample name, and must be entered exactly as it appears in the other testwork tables in order for the grouping functions to work properly.
Automatically generated fields are:
- #: the position in the current table. This value varies whenever the table sorting changes or when new data is entered.
- Program: the test program that this sample belongs to.
An optional comment field is available for assigning other information to a record. Examples of 'comment' information includes references to publications or drill hole dimensions (PQ, HQ).
Grouping of samples
Three special fields in the Litho table can be used for grouping samples. The names of these fields describe how they are typically used, but users are free to substitute other uses and are not restricted to entering the data described.
- litho is usually the dominant lithology of a sample. Examples are 'breccia', 'volcanic' or 'End member 1'.
- alteration is usually the dominate type of alteration of a sample. Examples are 'secondary enrichment', 'argillic' or 'quartz-sericite'.
- zone is usually a geographical or stratigraphic description of a sample. Examples are 'East zone', 'secondary enrichment' or 'main pit'.
In these examples, the term 'secondary enrichment' can go in any of the fields — how the fields are used should vary from deposit to deposit depending on what factors the geologists and metallurgists have determined are controlling the ore hardness and mineralization. The field names are only guidelines and the use of the fields can be tailored to suit a project's particular needs.
Drill hole identification
Four optional special fields applicable to samples derived from drill core are:
- drillhole: the name or number of the drill hole that a sample was derived from.
- dist_from and dist_to: the down-hole positions where the sample starts and ends. This value can be in the customary units of the project (metres, feet or other units).
- length the overall length of the interval tested within the sample. This is usually to minus from, but could be smaller if, for example, only every second metre was sampled for grinding.
It is customary to make each sample a single interval of a single drill hole. Mixing material from different drill holes or from non-adjoining intervals is not recommended as geologists and geostatisticians will not be able to relate the grindability samples back into the geological models (for performing geometallurgical modelling). See the commentary on test programs for more.
