Difference between revisions of "Testwork: Bond crushing work index"
(→Testwork: Bond Crushing Work Index) |
|||
| Line 1: | Line 1: | ||
[[category:Testwork]] |
[[category:Testwork]] |
||
[[category:Bond work index]] |
[[category:Bond work index]] |
||
| + | [[category:Testwork]] |
||
==Testwork: Bond Crushing Work Index== |
==Testwork: Bond Crushing Work Index== |
||
{{Test|name=Bond Low-Energy Impact Crushing Work Index|Abrev=Wi<sub>C</sub>|Alt=CWI IWI LEIT|F80=100 mm|P80=20 mm|Models=Bond models}} |
{{Test|name=Bond Low-Energy Impact Crushing Work Index|Abrev=Wi<sub>C</sub>|Alt=CWI IWI LEIT|F80=100 mm|P80=20 mm|Models=Bond models}} |
||
Revision as of 23:32, 17 December 2012
Contents
Testwork: Bond Crushing Work Index
| Test name | ||||
| Bond Low-Energy Impact Crushing Work Index | ||||
| ||||
| ||||
| Models | ||||
| Bond models |
The Bond low-energy impact crushing work index (more informally, the Bond crushing work index) is not as common as the Bond ball mill work index, and it is a notoriously noisy test.
The test is a 'per-specimen' test where individual specimens of prepared rock are hand-picked by the test operator and placed into the apparatus. Typically twenty specimens are chosen to represent a sample and the result reported is the average of those specimens.
There is a high-energy impact work index which is a different (and incompatible) test. The high-energy test has fallen into disuse and any recent (post year 2000) test labelled as a "crushing work index" can confidently be assumed to be the low-energy impact test.
Sample Requirements
The test requires 20 large lumps, minimum dimension 75 mm. When using drill core, use whole-diameter HQ or PQ size core.
Test Inputs
Not applicable.
Test Outputs
SAGMILLING.COM uses only metric units; if the laboratory reported work index in "short ton" units, multiply that value by 1.1023 and enter the result.
The laboratory will report the following information:
- N° specimens: The number of specimens tested (typically 20)
- min The metric work index of the sample with the lowest result
- max: The metric work index of the sample with the highest result
- stdev: The standard deviation of metric work index of all the samples
- WiC: The arithmetic average of the metric work index of all the samples
- density: The water-displacement density of the specimens prior to testing, in kg/L (also referred to as 'specific gravity')
Modelling
Crushing mill work index is used in the SAGMILLING.COM Bond/Barratt specific energy consumption model.
The work index is used to calculate the energy requirement to break rocks in the coarse size range, from >100 mm down to about 10 mm - 20 mm.
